Komatsu — Electrical System

OPERATION Other Troubleshooting Electrical System ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, contact your Komatsu distributor for repairs. * See “Every 250 Hours Service” on page 3-61. 2-186 WA430-6 Problem Main Causes Remedy Lamp does not glow brightly even when the engine runs at high speed. Lamp flickers while engine is running. • Defective wiring • Defective adjustment of belt tension • (Check, repair loose terminals, disconnections.) • Adjust alternator belt tension. * See EVERY 250 HOURS SERVICE. Even when the engine is rotating, the battery charge circuit caution lamp does not go out.

• Defective alternator • Defective wiring • Defective adjustment of alternator belt tension • (Replace.) • (Check, repair.) • Adjust alternator belt tension. * See EVERY 250 HOURS SERVICE. Abnormal noise is generated from alternator. • Defective alternator • (Replace.) Starting motor does not turn when starting switch is turned ON. • Defective wiring • Insufficient battery charge • Battery disconnect switch is in the ON position • (Check, repair.) • Charge. • Turn the battery disconnect switch to the OFF position Pinion of starting motor keeps going in and out. • Insufficient battery charge • Charge. Starting motor turns engine sluggishly.

• Insufficient battery charge • Defective starting motor • Charge. • (Replace.) Starting motor disengages before engine starts. • Defective wiring • Insufficient battery charge • (Check, repair.) • Charge. Preheating pilot lamp does not illuminate. • Defective wiring • Defective heater relay, heater controller, temperature sensor • Defective preheating pilot lamp • (Check, repair.) • (Replace.) • (Replace.) Even when engine is stopped, battery charge circuit caution lamp does not illuminate (starting switch at ON position). • Defective wiring • Defective monitor • (Check, repair.) • (Replace.)