OPERATION Chassis ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, contact your Komatsu distributor for repairs. * See “When Required” on page 3-28. ** See “Every 100 Hours Service” on page 3-59. WA430-6 2-187 Problem Main Causes Remedy Transmission Engine is running but machine does not move. • Parking brake applied • Directional lever is not shifted properly • Lack of oil in transmission case • Release parking brake. • Shift lever properly. • Add oil to specified level. * See WHEN REQUIRED. Even when engine is run at full throttle, machine only moves slowly and lacks power.
• Lack of oil in transmission case • Screen is clogged • Add oil to specified level. * See WHEN REQUIRED. • (Disassemble, clean.) Oil overheats. • Too much oil or too little oil in transmission case • Machine is not traveling in correct speed range • Torque converter is stalled for long periods • Engine is overheating • Add or drain oil to specified level. * See WHEN REQUIRED. • Place in correct speed range. • Reduce stall time. • (Check engine.) Noise generated. • Lack of oil in transmission case • Add oil to specified level. * See WHEN REQUIRED. Axle Noise generated. • Lack of oil • Improper oil used (for machines with limited slip differential) • Add oil to specified level.
* See WHEN REQUIRED. • Replace with specified oil. Brake Brake is not applied when pedal is depressed. • Disc has reached wear limit • Lack of oil in hydraulic tank • Air in brake line • (Replace disc.) • Add oil to specified level. ** See EVERY 100 HOURS SERVICE. • Bleed air. Brake drags or remains applied. • Vent hole of brake valve is clogged • Clean Brakes squeal • Disc is worn. • Large amount of water in axle oil • Deteriorated axle oil due to overuse of brake • (Replace disc.) • Change axle oil. • Change axle oil.