Welding Instructions MAINTENANCE Turn the engine starting switch off; wait for approximately one minute; turn off all power to the electrical system by turning the battery disconnect switch (if applicable) and take out the battery disconnect switch key. Then disconnect the battery negative (-) terminal. Do not apply more than 200V continuously. Connect grounding cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near instruments, connectors, etc., the instruments may malfunction. Avoid seals or bearings located between the area to be welded and the grounding point.
Do not use the area around the work equipment pins or hydraulic cylinders as the grounding point. Do Not Drop Things Inside the Machine When opening inspection windows or the oil filler port of the tank to perform an inspection, be careful not to drop nuts, bolts, or tools inside the machine. If such things are dropped inside the machine, it may cause damage and/or malfunction of the machine and will lead to failure. Do not put unnecessary things in your pockets. Carry only things which are necessary to perform inspection or maintenance. If you drop anything inside the machine, always remove it immediately. Dusty Work Sites When working at dusty work sites, do the following:
Check the air cleaner clogging caution lamp more frequently to check the degree of clogging of the air cleaner. Clean the radiator core frequently to avoid clogging. Clean and replace the fuel filter frequently. Clean electrical components, especially the starting motor and alternator, to avoid an accumulation of dust. When inspecting or changing oil, move the machine to a place that is free of dust to prevent dirt from getting into the oil. Avoid Mixing Oil Never mix different brands or grades of oil. If a different brand or grade of oil must be added, drain the old oil and replace all the oil with the new brand or grade of oil.
Locking Inspection Covers Lock the inspection cover in position securely with the lock bar. If inspection or maintenance is performed with the inspection cover open and not locked into position, there is a danger that it may be suddenly blown shut by the wind and injure the worker. Bleeding Air from Hydraulic Circuit After repairing or replacing parts of the hydraulic circuit, or removing the piping of the hydraulic circuit, it is necessary to bleed the air from the circuit. See “Change Oil in Hydraulic Tank, Replace Hydraulic Filter Element” on page 3-79. WA430-6 3-3