MAINTENANCE Precautions When Installing Hydraulic Hoses When removing parts at locations where there are O-rings or gasket seals, clean the mounting surface and replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gaskets. When installing hoses, do not twist or bend them sharply. If installed in this manner, the hose will be damaged and its service life drastically reduced. Checks After Inspection and Maintenance If you forget to perform the checks after inspection and maintenance, unexpected problems may occur. This may lead to serious injury or property damage. Always do the following checks.
Checks After Operation (with engine stopped) Have any inspection and maintenance points been forgotten? Have all inspection and maintenance items been performed correctly? Have any tools or parts been dropped inside the machine? It is particularly dangerous if parts are dropped inside the machine and get caught in the lever linkage mechanism. Are there any coolant or oil leaks? Have all nuts and bolts been tightened? Checks When Engine is Running Be extremely careful to ensure safety during this operation. When checking the operation of the engine, see “Running the Machine During Maintenance” on page 1-44. Check that the component/system that was inspect and maintained is working properly.
Increase the engine speed and check for coolant, oil, and fuel leaks. 3-4 WA430-6