SERVICE OUTLINE MAINTENANCE Always use Komatsu genuine parts for replacement parts, grease, or oil. When changing or adding oil, do not mix different types of oil. When changing the type of oil, drain all the old oil and fill completely with the new oil. Always replace the filter at the same time as you change the oil. (There is no problem if the small amount of oil remaining in the piping mixes with the new oil.) Unless otherwise specified, when the machine is shipped from the factory, it is filled with the oil and coolant listed in the following table.
Handling Oil, Fuel, Coolant, and Performing Oil Clinic Oil Oil is used in the engine and hydraulic equipment under extremely severe conditions (high temperature, high pressure); it deteriorates with use. Always use oil that matches the grade and maximum and minimum ambient temperatures recommended in this manual. See “RECOMMENDED FUEL, COOLANT, AND LUBRICANTS” on page 3-12. Even if the oil is not dirty, always change the oil after the specified interval. Oil corresponds to blood in the human body; it is crucial to the functioning of the machine. Always be careful when handling it to prevent any impurities (water, metal particles, dirt, etc.) from getting into the oil.
The majority of problems with machines are caused by the entry of such impurities. Take particular care not to contaminate the oil when storing or adding it. Never mix oils of different grades or brands. Always add the specified amount of oil. Having too much oil or too little oil both cause problems. If the oil in the work equipment is not clear, there is probably water or air getting into the circuit. In such cases, contact your Komatsu distributor for inspection and repair. When changing the oil, always replace the related filters at the same time. Komatsu strongly recommends that you have an analysis made of the oil periodically to check the condition of your machine.
For details of this service, contact your Komatsu distributor. When using commercially available oil, it may be necessary to reduce the oil change interval. We recommend that you use the Komatsu oil clinic to carry out a detailed check of the characteristics of the oil. WA430-6 3-5 Item Type Engine oil pan Engine oil EO15W40-DH (Komatsu genuine parts) Transmission case Power train oil TO10 (Komatsu genuine parts) Hydraulic oil system Power train oil TO10 (Komatsu genuine parts) Axle Axle oil AXO80 (Komatsu genuine parts) Radiator Supercoolant AF-NAC (Komatsu genuine parts) (density: 30% or above)