Komatsu — Coolant and Water for Dilution

MAINTENANCE Fuel To prevent the moisture in the air from condensing and forming water inside the fuel tank, always fill the fuel tank after completing the day’s work. The fuel pump is a precision instrument. If fuel containing water or dirt is used, the fuel pump cannot work properly. Be extremely careful not to let impurities get into the fuel when storing or adding it. Always use the fuel specified for the temperature. See “RECOMMENDED FUEL, COOLANT, AND LUBRICANTS” on page 3-12. The fuel will solidify if it is used at temperatures lower than the specified temperature (particularly at temperatures below -15 ° C (5 ° F)).

If the fuel is used at temperatures higher than the specified temperature, the viscosity will drop. This may result in problems such as a drop in output. Before starting the engine, or when ten minutes have passed after adding fuel, drain the sediment and water from the fuel tank. If the engine runs out of fuel, or if the filters have been replaced, it is necessary to bleed the air from the fuel line. If there is any foreign material in the fuel tank, wash the tank and fuel system. Remark Always use diesel fuel. The engine mounted on this machine uses an electronically controlled, high-pressure fuel injection device to ensure good fuel consumption and exhaust gas characteristics.

This device requires high precision parts and lubrication. If low viscosity fuel with low lubricating ability is used, the durability of the engine may drop markedly. Coolant and Water for Dilution Coolant prevents corrosion and freezing. Even in areas where it is not necessary to prevent freezing, the use of antifreeze coolant is essential. Use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anti-corrosion, antifreeze, and cooling properties and can be used continuously for two years or 4,000 hours.

Komatsu Supercoolant (AF-NAC) is strongly recommended. We do not recommend the use of any coolant other than Komatsu genuine Supercoolant (AF-NAC). If you use another coolant, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light medals, such as aluminum. When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. For details, see “Clean Inside of Cooling System” on page 3-33. When diluting the antifreeze coolant, use distilled water or tap water (soft water). Natural water, such as river water or well water (hard water), contains large amounts of minerals (calcium, magnesium, etc.).

This makes it easier for scale to form inside the engine or radiator. Once scale is deposited inside the engine or radiator, it is extremely difficult to remove it. The deposition of scale also causes overheating due to poor heat exchange. When you dilute the coolant, we recommend that you use water with an overall hardness of less than 100 PPM. When using antifreeze, always observe the precautions given in Section 1 of this manual. See “Cooling System Precautions” on page 1-45 and “Disposal of Waste Materials” on page 1-51. 3-6 WA430-6