Komatsu — Filters

Antifreeze coolant is flammable; be sure to keep it away from flames. MAINTENANCE The ratio of Supercoolant (AF-NAC) to water differs according to the ambient temperature. For details of the ratio when mixing, see “Clean Inside of Cooling System” on page 3-33. Supercoolant (AF-NAC) may be supplied already mixed. In such cases, never dilute with water. If the engine overheats, wait for the engine to cool before adding coolant. If the coolant level is low, it will cause overheating; it will also cause problems with corrosion due to air entering the coolant. Grease Grease is used to prevent seizure and noises at the joints. This construction equipment is used under heavy-duty conditions.

Always use the recommended grease and follow the change intervals and ambient temperatures given in this manual. Grease fittings not included in the MAINTENANCE section are grease fittings that are used at the time of overhaul; there is no need to grease these points. When using the machine after it has been in storage for a long time, carry out greasing if there is any stiffness or screeching. If any part becomes stiff or makes noise after being used for a long time, apply grease. Always wipe off all of the old grease that is pushed out when greasing.

Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. Storing Oil and Fuel When keeping a drum for a long period, put the drum on its side so that the filler port of the drum is at the side. Keep oil or fuel indoors to prevent any water, dirt, or other impurities from getting into it. This action prevents moisture from being sucked into the drum. If the drum must be stored outside, cover it with a waterproof sheet or take other measures to protect it.

To prevent any change in quality during long-term storage, be sure to use the oil or fuel in the order of “first in - first out” (use the oldest oil or fuel first). Filters Filters are extremely important safety parts. Filters prevent impurities in the fuel and air circuits from entering important equipment where they could cause problems. Replace all filters periodically. Details are provided in the SERVICE PROCEDURE section of this manual. When working in severe conditions, replace the filters at shorter intervals according to the oil and fuel (sulfur content) being used. Never try to clean the filters (cartridge type) and use them again. Always replace with new filters.

When replacing oil filters, check if any metal particles are attached to the old filter. If you find any metal particles, contact your Komatsu distributor. When replacing the engine oil filter, fill the new filter with the specified clean oil and then install it. Do not open packs of spare filters until just before they are to be used. Always use Komatsu genuine filters. WA430-6 3-7