Komatsu — Requirements for Using Biodiesel Fuel in Komatsu Engines

MAINTENANCE Certification and Standards Komatsu certifies its engines based on the use of the prescribed EPA and European Certification Fuels. Komatsu does not certify its engines on any other fuels. It is the user’s responsibility to use the correct fuel as recommended by Komatsu and allowed by the EPA or other local regulatory agencies. In the United States, the EPA allows only registered fuels and fuel additives to be used in commerce. The EPA has provided a web site for additional alternative fuel information at:

http:/www.epa.gov/otaq/consumer/fuels/altfuels/altfuels.htm The specifications for biodiesel are described in the ASTM D6751 Standard in North America and the EN14214 Standard in Europe. These specifications do not cover the fuel blends that may be purchased by the end user. Despite the specifications and standards, the quality of available biodiesel remains inconsistent. To use biodiesel in Komatsu engines, it is imperative that the biodiesel fuel be of high quality. The biodiesel fuel must meet or exceed the specifications outlined by Komatsu or engine damage will occur. In order for the customer to successfully use biodiesel, it is recommended that the fuel be of high quality.

The biodiesel fuel must meet or exceed the specifications outlined by Komatsu. It is the responsibility of the customer/user to verify/obtain the proper local, regional, or national exemptions required for the use of biodiesel in any emissions-regulated Komatsu engine. If these items are disregarded, engine damage may occur. Warranty and Use of Biodiesel Fuel in Komatsu Engines The Komatsu warranty covers failures that are a result of defects in material or factory workmanship.

Engine damage, service issues, and/or performance issues, determined by Komatsu to be caused by use of biodiesel fuel not meeting the specifications as outlined here, are not considered to be defects in material or workmanship and are not covered under the Komatsu warranty. Requirements for Using Biodiesel Fuel in Komatsu Engines Applications for diesel and biodiesel fuel blends of up to B5 must meet the requirements of ASTM D975 D1 and D2 fuels. An acceptable biodiesel fuel blend of up to 20% volume concentrate (B20) biodiesel with 80% petrodiesel can be used for all Komatsu engines.

End users must adhere to the following Komatsu requirements when using biodiesel blends above B5 and up to B20. Remark Komatsu requires that biodiesel blends be purchased from a BQ-9000 Certified Marketer. The B100 biodiesel fuel used in the blend must be sourced from a BQ-9000 Accredited Producer. Certified Marketers and Producers can be found at this web site: http://www.bq-9000.org. Oil Sampling Under certain biodiesel operating conditions, fuel dilution of lubricating oil has been observed. Monitoring fuel dilution can be accomplished by performing oil sampling. Fuel levels in lubricating oil must not exceed 5%.

In order to determine if the oil change interval needs to be modified, the end user is required to use oil sampling during the first six months of operation to monitor engine oil condition and fuel dilution of lubricating oil. 3-16 WA430-6