Fuel Water Separation MAINTENANCE Biodiesel has a natural affinity to water and water leads to accelerated microbial growth. Storage tanks must be equipped with a fuel water separator to make sure water is eliminated before entering the machine’s fuel tank. The machine should be equipped with a water separator as well. It is recommended that storage and machine fuel tanks are kept full in order to reduce potential condensation. Due to the solvent nature of biodiesel and the potential for cleaning of the vehicle fuel tank and lines when using biodiesel, new fuel filters must be installed when switching to biodiesel. Fuel filters must be replaced more frequently.
Specifically, the first two fuel filter changes, after biodiesel introduction, must be done at one half the standard interval; that is, if the standard interval is 500 hours then the fuel filter must be changed at 250 hours. Komatsu Genuine fuel filters must be used for fuel filter changes. Biodiesel Fuel Storage Biodiesel fuel must be used within six months of its manufactured date. Long-term storage problems have occurred with biodiesel due to its poor oxidation stability. This poor oxidation stability is accelerated with increased ambient temperature. For this reason, Komatsu does not recommend using biodiesel for low use applications, such as standby power or seasonal applications.
Your fuel supplier can recommend oxidation stability additives. Avoid storing equipment with biodiesel blends in the fuel system for more than three months or fuel system damage can occur. When using biodiesel for seasonal applications, the engine and fuel systems must be purged before storage by running the engine on pure diesel fuel for a minimum of 30 minutes. When storing biodiesel in bulk storage tanks, the systems must be properly cleaned and maintained. Steps must be taken to minimize moisture and microbial growth in storage tanks. Consult your fuel supplier for assistance in storing and handling biodiesel.
Properties of Biodiesel Energy Content B100 biodiesel provides approximately 7% to 10% less energy per gallon of fuel when compared to conventional diesel fuels. Depending on the application, operating with B20 biodiesel blends can result in a slight decrease in fuel economy and power. Engine Material Compatibility Biodiesel may affect engine elastomers; periodic checks of seals and hoses is required. As previously mentioned, biodiesel has excellent cleaning properties and fuel filters must be replaced and inspected more frequently. Specifically, the first two fuel filter changes, after biodiesel introduction, must be done at one half the standard interval.
When replacing fuel filters at any time, Komatsu strongly recommends that fuel filters be inspected, especially for metal particles. Low Temperature Performance Biodiesel properties change with ambient temperature change. In low ambient temperature, biodiesel will start turning waxy or gelling. Precautions must be taken when storing this fuel at low temperatures by using a heated building or a heated storage tank. Additives can be used for low ambient operation. The fuel system may require heated fuel lines, filters, and tanks to avoid being plugged by biodiesel fuel solidifying in low ambient temperatures. A fuel heater is recommended for ambient temperatures below -5°C (23°F).
Consult your fuel and additive supplier for assistance in attaining proper cloud point fuel; see cloud point on 3-15. WA430-6 3-17