Komatsu — Clean, Replace Air Cleaner Element

5. Clean the inside of the air cleaner body, the cover (2), and evacuator valve (5). MAINTENANCE 6. Check the condition of the O-ring (6). You must replace the O-ring if it is damaged (scratches, etc.). 7. Direct dry compressed air (max. 0.69 MPa (100.1 psi)) from the inside of the outer element along its folds. Then direct the compressed air from the outside along the folds, and again from the inside. 8. After cleaning the element, check it by shining a light through it. If you find any small holes or thin cracks, replace the element. When cleaning the element, do not hit it or beat it against anything. Do not use an element that has damaged folds, gaskets, or seals. 9.

Insert the clean outer element into the air cleaner; then install the O-ring (6) and cover (2). Make sure that the O-ring is not damaged. WA430-6 3-29