MAINTENANCE Check Additional Water Separator, Clean Inside Case For poor fuel arrangement specification The engine fuel piping system is under high internal pressure when the engine is running. Always reduce the internal pressure before draining water or replacing the element cup. This engine consists of higher precision parts than on the conventional fuel injection pump and nozzle. If dirt gets in, it will cause problems. If there is any dirt stuck to the fuel line, use fuel to wash it off completely. Do not bring fire close. When carrying out inspection and maintenance of the fuel system, be particularly careful not to let any dirt or dust get in.
If there is any dirt of dust around the fuel system, clean it off thoroughly with fuel before starting the operation. To prevent dirt or dust from getting into the fuel circuit, remove all dirt and dust from the surrounding area before starting the operation. Required Container to catch the fuel 1. Stop the engine and open the engine side cover on the right side of the chassis. 2. Drain the water and fuel. For details, see “Check Additional Water Separator, Drain Water” on page 2-84. 3. Loosen the ring nut (1), then remove case (2). 4. Pull screen (5) down to remove it from the water separator holder (3). 5. Wash screen (5) in clean fuel. Check screen (5) and replace it if it is damaged. 6.
Wash the inside of case (2) with clean fuel. Check case (2). If it is scratched, damaged, or so dirty that the position of float (6) cannot be checked, replace case (2). 7. Wash the inside of water separator holder (3) with clean fuel. 8. Install screen (5) to the water separator holder and replace O- ring (7) with a new part. 9. Tighten plug (4) and insert in case (2). Be careful not to let float (6) be at an angle. Tightening torque: . . . . . . . . . . . . . . . . . . 2 – 3 N•m (18 – 27 lbf in) 10. Install case (2) to the water separator holder (3), then tighten ring nut (1). Tightening torque:. . . . . . . . . . . . . . . . . 23 – 27 N•m (17 – 20 lbf ft) 11.
After completing the inspection and cleaning, bleed the air. For details of bleeding the air, see “Bleeding Air from Fuel Line” on page 3-73. 3-32 WA430-6