Clean Inside of Cooling System MAINTENANCE Use a ladder or stand when removing or replacing the radiator cap and when adding water. Immediately after stopping the engine, the engine coolant is very hot and the pressure inside the radiator is high. Removing the cap and draining the coolant under this condition could cause burns. Allow the engine to cool down and then turn the cap slowly to release the pressure. Start the engine and flush the system. When standing up or leaving the operator’s seat, set the work equipment lock lever to the LOCK position.
For details about starting the engine, see “Check Before Starting Engine” on page 2-80, “Adjustments” on page 2-90, and “Starting Engine” on page 2-98. When the undercover is removed, there is danger of touching the fan. Never enter the rear of the machine when the engine is running. Stop the machine on level ground when cleaning the cooling system or changing the coolant. Clean the inside of the cooling system and change the coolant according to the schedule in the following table. When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover. Consult your Komatsu distributor for installation instructions.
When using corrosion resistor, use Komatsu genuine corrosion resistor. If you use another corrosion resistor, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. The coolant prevents corrosion as well as freezing. Even in areas where freezing is not an issue, the use of antifreeze coolant is essential. Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC).
Komatsu Supercoolant (AF-NAC) has excellent anti-corrosion, antifreeze, and cooling properties and can be used continuously for two years or 4,000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine Supercoolant (AF-NAC). If you use another coolant, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light medals, such as aluminum. To maintain the anti-corrosion properties of Supercoolant (AF-NAC), always keep the density of the Supercoolant between 30% and 68%.
When deciding the proportions for mixing the coolant with water, check the lowest recorded temperature for your area and use the Water and Supercoolant Mix Ratio table on page 3-34 to decide the mixing ratio. It is better to estimate a temperature about 10 ° C (50 ° F) lower than the minimum temperature. WA430-6 3-33 Antifreeze Coolant Interval for Cleaning Inside Cooling system and Changing Antifreeze Coolant Precautions for Use Komatsu Supercoolant (AF-NAC) Every two years or every 4,000 hours whichever comes first 1 ★