Komatsu — Clean Axle Case Breather

MAINTENANCE Clean Axle Case Breather Apply the parking brake and lock the front and rear frames with the frame lock bar. 1. Set the parking brake switch to the ON position (A). 2. Lower the work equipment to the ground; stop the engine; and wait for the temperature of all parts to go down. 3. Set the frame lock bar to the LOCK position (L) to lock the front and rear frames. 4. Use a brush to clean off all the mud or dirt from around the breather. A: Front axle B: Rear axle 5. Remove the breather and soak it in cleaning liquid, then clean it. 6. Clean the breather at two places (front and rear). Remark When removing the breather, be careful that dirt or dust does not get into the mount. 7.

Install the breather. 3-40 WA430-6