Every 100 Hours Service MAINTENANCE Maintenance for every 50 hours service should be performed at the same time. Lubricate Rear Axle Pivot Pin Three sites to be greased 1. Using a grease pump, pump in grease through the grease fittings marked by the arrows in the graphic. 2. After greasing, wipe off any old grease that was pushed out. Check Oil Level in Hydraulic Tank, Add Oil The parts and oil are very hot immediately after stopping the engine, and may cause burns. Wait for the temperature to decrease before starting the work. When removing the oil filler cap, turn it slowly to release any internal pressure and then remove it. 1.
Park the machine on a level surface; lower the bucket to the ground; stop the engine; and wait for approximately five minutes. 2. Check the oil level with sight gauge (G) on the hydraulic tank. The oil level should be between the H and L marks. If the oil level is above the H level, drain the excess oil from the drain plug. Using the machine with excess oil in the circuit will cause damage to the hydraulic circuit or cause the oil to spurt out. If the oil is below the L mark, add oil through oil filler port (F). WA430-6 3-59