Komatsu — Change Oil in Engine Oil Pan, Replace Engine Oil Filter Cartridge

Every 500 Hours Service MAINTENANCE Maintenance for every 50, 100, and 250 hours service should be performed at the same time. Change Oil in Engine Oil Pan, Replace Engine Oil Filter Cartridge The engine parts and oil are very hot immediately after the engine is stopped and may cause serious burns. Wait for the temperature to cool down before starting the work. When removing the oil filler cap, turn it slowly to release internal pressure and then remove it. Required Filter wrench Container to catch engine oil Refill capacity:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 l (8 gal) 1. Stop the engine and wait for the temperature of all parts to go down.

Wait for ten minutes before starting the operation. 2. Open the engine side cover on the right side of the chassis. 3. Open oil filler (F). 4. Place a container under drain plug (P) to catch the oil. 5. Loosen drain plug (P) and drain the oil. 6. Check the drained oil. If there are excessive metal particles or foreign material, contact your Komatsu distributor. 7. Install drain plug (P). 8. Open the engine side cover on the left side of the machine. 9. Using the filter wrench, turn filter cartridge (1) counterclockwise to remove it. Make sure that you have waited for ten minutes before starting the operation. Otherwise a large amount of oil will come out. 10. Clean the filter holder. 11.

Fill a new filter cartridge with clean engine oil; coat the seal and thread of the filter cartridge with engine oil (or coat with a thin layer of grease). 12. Install the new filter cartridge to the filter holder. When installing the cartridge, bring the seal surface into contact with the filter holder and then tighten a further 3/4 to one turn by hand. WA430-6 3-67