Komatsu — Replace Fuel Prefilter Cartridge

Replace Fuel Prefilter Cartridge MAINTENANCE Immediately after the engine is stopped, all parts are very hot. Do not replace the filter immediately. Wait for the engine to cool down before starting the operation. High pressure is generated inside the engine fuel piping system when the engine is running. When replacing the filter, wait for at least 30 seconds after the engine stops to let the internal pressure go down before replacing the filter. Do not bring any fire or spark close. Remark Genuine Komatsu fuel filter cartridges use a special filter that has a highly efficient filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part.

The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Never use substitute parts. When performing inspection or maintenance of the fuel system, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. Required Container to catch fuel Filter wrench 1. Stop the engine. 2. Open the engine side cover on the right side of the chassis.

The fuel prefilter forms one unit with the water separator and is installed at the rear of the engine. 3. Remove connector (1). After removing the connector, cover the connector terminals with a vinyl bag or tape to protect them and prevent them from becoming dirty. 4. Set the container to catch the fuel under the filter cartridge. 5. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. WA430-6 3-69