MAINTENANCE 6. Take water separator cup (3) installed on the bottom of the cartridge and turn it to the left to remove it. If the cup is broken or damaged, replace it with a new part. 7. Clean transparent cup (3) and remove the seal ring. Replace the seal ring with a new part. 8. Coat the new seal ring with clean fuel and install it to the cup (3). 9. Install cup (3) to the bottom of the new prefilter cartridge. Tightening torque for cup: . . . . . . . . . . . . . . . . . . 10 N•m (89 lbf in) 10. Check that drain plug (4) at the bottom of cup (3) of the fuel prefilter is tightened securely. Tightening torque: . . . . . . . . . . . . . . 0.2 – 0.45 N•m (1.8 – 4 lbf in) 11.
Clean the filter holder. 12. Check that cap (A) is installed to the new filter cartridge and then fill with clean fuel through the eight small holes (B) . Remark When filling with fuel, always use fresh fuel and be careful not to let any dirt or dust get into the fuel cartridge. Cap (A) prevents fuel, containing dirt, from getting into the filter cartridge. Always add the fuel with cap (A) installed. 13. Coat the packing surface of the filter cartridge with oil. 14. Remove filter cartridge cap (A) and dispose of it. 15. Install the filter cartridge to the filter holder.
When installing, tighten until the packing surface contacts the seal surface of the filter holder and then tighten it 3/4 of a turn. If the filter cartridge is tightened too much, the packing will be damaged; this will result in leakage of fuel. If the filter cartridge is too loose, fuel will leak from the packing. Always tighten the filter cartridge the correct amount. If tightening with a wrench, be very careful not to dent or damage the filter. 16. Connect connector (1). 17.
If it is necessary to replace the fuel main filter cartridge (EVERY 1000 HOURS) at this time, follow the instructions in “Replace Fuel Main Filter Cartridge (Standard Specification)” on page 3-72 or “Replace Fuel Main Filter Cartridge (Poor Fuel Arrangement Specification)” on page 3-74. Do not put fuel in the main filter cartridge. 18. Start the engine; check that there is no leakage of fuel from the filter seal surface or water separator mounting surface; then run at low idle for approximately ten minutes. 3-70 WA430-6