Komatsu — Replace Fuel Main Filter Cartridge (Standard Specification)

9. Install the filter cartridge to the filter holder. MAINTENANCE When installing the filter cartridge, tighten until the packing surface contacts the seal surface of the filter holder and then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged; this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will leak from the packing. Always tighten the filter cartridge the correct amount. When tightening with a filter wrench, be extremely careful not to dent or damage the filter. 10. After replacing the fuel main filter cartridge, bleed the air from the fuel line. Bleeding Air from Fuel Line 1. Fill the fuel tank with fuel.

Fuel capacity: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 325 l (86 gal) 2. Open the engine side cover on the right side of the chassis. 3. Loosen and pull out feed pump knob (1) and move it forward and backward. It is not necessary to remove the plug on the side surface of the fuel prefilter head. Keep moving knob (1) until it becomes heavy. 4. After bleeding air, push in and tighten knob (1). 5. Crank the engine with the starting motor (starting rotation of starting motor) and start the engine. When the engine is cranked, the air is automatically bled from the high-pressure circuit.

If the engine does not start, the air has probably not been bled properly from the low-pressure circuit. Repeat the procedure from Step A. If the engine is operated with air remaining in the fuel circuit, an error (CA449, CA559) may be generated in the fuel system. If this happens, keep the throttle at Lo after starting the engine and run the engine continuously for approximately three minutes. When the air is bled and the engine rotation becomes stabilized, the error display will go out. 6. After completing the air bleeding, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage of fuel, check the tightening of the filter cartridge.

If there is still leakage of fuel, return to the Replace Fuel Main Filter Cartridge (Standard Specification) procedure and follow Steps 3 and 4 to remove the filter cartridge, then check the packing surface for damage or foreign material. If any damage or foreign material is found in the packing, replace the cartridge with a new part, then repeat Steps 5 - 9 to install the filter cartridge. WA430-6 3-73