Komatsu — Replace Fuel Main Filter Cartridge (Poor Fuel Arrangement Specification)

MAINTENANCE Replace Fuel Main Filter Cartridge (Poor Fuel Arrangement Specification) After the engine has been operated, all parts are very hot. Do not replace the filter immediately. Wait for all parts to cool down before starting the operation. High pressure is generated inside the engine fuel piping system when the engine is running. When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pressure go down, before replacing the filter. Do not bring any fire or flame close. Remark Genuine Komatsu fuel filter cartridges use a special filter that has a highly efficient filtering ability.

When replacing the filter cartridge, always use a genuine Komatsu part. The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Never use substitute parts. When carrying out inspection or maintenance of the fuel system, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. If it is necessary to replace the fuel prefilter cartridge, see “Replace Fuel Prefilter Cartridge” on page 3-69.

Required Container to catch oil Filter wrench 1. Stop the engine. 2. Open the engine side cover on the right side of the chassis. 3. Set the container to catch the fuel under the filter cartridge. 4. Using a filter wrench, turn filter cartridge (1) counterclockwise to remove it. 5. Clean the filter holder. 6. Check that cap (A) is installed on the new filter cartridge. Remark Cap (A) prevents dirt from getting into the filter cartridge 7. Coat the packing surface of the new filter cartridge with oil. Do not fill the fuel main filter cartridge with fuel. 8. Remove filter cartridge cap (A) and discard it. 3-74 WA430-6