MAINTENANCE Change Oil in Transmission Case, Replace Oil Filter Cartridge, Clean Strainer Immediately after stopping the engine, the parts and oil are very hot and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure and then remove the cap. Required Filter wrench Container to catch oil Refill capacity:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 l (11 gal) 1. Stop the engine and wait for the temperature of all parts to go down. 2. Set a container to catch the drained oil directly under drain plug (P). 3. Remove drain plug (P) and drain the oil.
To prevent the oil from spurting out, loosen the drain plug slowly and then gradually remove it. 4. After draining the oil, install and tighten drain plug (P). Tightening torque: . . . . . . . . . . . . . . . . 68.6 ±9.8 N•m (51 ±7 lbf ft) 5. Set a container directly under the transmission filter to catch the oil. 6. Remove drain plug (1) of the transmission filter; drain the oil; then tighten the plug again. 7. Using a filter wrench, turn filter cartridge (2) to the left to remove it. 8. Clean the filter holder; coat the seal surface and thread of the new filter cartridge with engine oil; then install it. 9.
When the seal surface comes in contact with the filter holder, tighten a further 2/5 of a turn with the filter wrench. 10. Remove four bolts (3); move tube (4); then remove strainer (5). 11. Remove any dirt stuck to strainer (5), then wash it in clean diesel fuel or flushing oil. If strainer (5) is damaged, replace it with a new part. 12. Install strainer (5) in the case. 13. Replace the O-ring of tube (4) with a new part, then install tube (4). 3-76 WA430-6