Komatsu — Lubricating

14. Refill the specified quantity of oil through oil filler (F). MAINTENANCE 15. After filling with oil, check that the oil is at the specified level. For details, see “Check Transmission Oil, Add Oil” on page 3- 37. 16. Check that there is no leakage of oil from the transmission case or oil filter. Clean Transmission Case Breather 1. Stop the engine and wait for the temperature of all parts to go down. 2. Loosen bolt (1) and remove cover (2). 3. Remove all mud and dirt from around the breather. 4. Remove breather (3) and fit a cover to the breather mounting hole to prevent dirt from entering. 5. Soak the breather in flushing liquid and wash it. 6. Install the breather. Lubricating 1.

Using a grease pump, pump in grease through the grease fittings marked by the arrows. 2. After greasing, wipe off any old grease that was pushed out. (1) Center hinge pin (two places) (2) Drive shaft center support (one place) WA430-6 3-77