MAINTENANCE Check Engine Air Intake Piping Clamps for Looseness Contact your Komatsu distributor to check the clamps between the air cleaner, turbocharger, after cooler and engine. Check Alternator Drive Belt Tension, Replace Since inspection and replacement of the fan belt requires special tools, contact your Komatsu distributor. The machine is equipped with an auto tensioner; there is no need to adjust the tension. If the alternator drive belt exhibits any of the following problems, the belt must be replaced. Ask your Komatsu distributor to replace the belt.
When horizontal scratch (1) crosses vertical scratch (2) When there are tears (3) in part of the belt In case (4) where there are horizontal scratches only, there is no need to replace the belt. Replace Corrosion Resistor Cartridge (Standard Specification) 1. Stop the engine and wait for the temperature of all parts to go down. 2. Close valve (1) of the corrosion resistor at two points. 3. Using a filter wrench, turn cartridge (2) to the left to remove it. 4. Apply engine oil to the sealing surface of a new cartridge and then install it to the filter holder.
When installing the cartridge, bring the packing surface in contact with the seal surface of the filter holder and then tighten it a further 2/3 of a turn. 5. Open valve (1) of the corrosion resistor at two points. 6. After replacing the cartridge, start the engine and check that there is no leakage of water from the cartridge seal surface. Replace Corrosion Resistor Cartridge (Poor Fuel Arrangement Specification) 1. Stop the engine and wait for the temperature of all parts to go down. 2. Close valve (1) of the corrosion resistor at two points. 3. Using a filter wrench, turn cartridge (2) to the left to remove it. 4.
Apply engine oil to the sealing surface of a new cartridge and then install it to the filter holder. When installing the cartridge, bring the packing surface in contact with the seal surface of the filter holder and then tighten it a further 2/3 of a turn. 5. Open valve (1) of the corrosion resistor at two points. 6. After replacing the cartridge, start the engine and check that there is no leakage of water from the cartridge seal surface. 3-78 WA430-6