Komatsu — Change Oil in Hydraulic Tank, Replace Hydraulic Filter Element

Every 2000 Hours Service MAINTENANCE Maintenance for every 50, 100, 250, 500, and 1,000 hours service should be performed at the same time. Change Oil in Hydraulic Tank, Replace Hydraulic Filter Element The parts and oil are at high temperature immediately after the engine is stopped and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure and then remove it. Required Container to catch oil. Refill capacity:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

139 l (37 gal) Before removing the oil filter cap for a filter or oil change, clean around the filter cap to avoid any dust or dirt from entering the hydraulic system. Dust or dirt can damage the system. 1. Lower the bucket horizontally to the ground and turn the parking brake switch to the ON position (A). 2. Stop the engine and wait for the temperature of all parts to go down. 3. Remove oil filler cap (F). 4. Set a container to catch the oil under drain plug (2). 5. Remove drain plug (2). 6. Loosen drain valve (3), then gradually pull it out to drain the oil. 7. After draining the oil, close drain valve (3), then install and tighten drain plug (2). Tightening torque: Drain plug (2): . . .

. . . . . . . . . . . . . . . . . . 69 ±10 N•m (51 ±7 lbf ft) Drain valve (3): . . . . . . . . . . . . . . . . . . . 64 ±15 N•m (47 ±11 lbf ft) WA430-6 3-79