Komatsu — Change Oil in Hydraulic Tank, Replace Hydraulic Filter Element

MAINTENANCE 8. Remove mounting bolt (5) of filter cover (4) at the top of the tank, then remove the cover. When doing this, the cover may fly off under the force of spring (6); keep the cover pressed down when removing the bolts. 9. Remove spring (6) and bypass valve (7), then take out element (8). 10. Check that there is no foreign material inside the tank, then clean it. 11. Install new element (8), then set bypass valve (7), spring (6), and cover (4) on the tank. When doing this, check the cover O-ring. If it is damaged or deteriorated, replace it. 12. Remove six bolts (10), then remove cover (9). 13. Pull the top of rod (11) from the top and remove strainer (12). 14.

Remove any dirt stuck to strainer (12), then wash it in flushing oil. 15. Install strainer (12), rod (11), and cover (4). If strainer (12) is damaged, replace it with a new part. 16. When installing the cover bolts (10), push down the cover and tighten the bolts evenly. 17. Add the specified amount of engine oil through oil filler port (F), then install cap (F). 18. Check that the hydraulic oil is at the standard level. For details, see “Check Oil Level in Hydraulic Tank, Add Oil” on page 3-59. 19. Run the engine at low idle. Extend and retract the steering, bucket and lift arm cylinders four to five times.

Be careful not to operate the cylinder to the end of its stroke (stop approximately 100 mm (3.94 in) before the end of stroke). Remark If the engine is run at high speed immediately after startup or a cylinder is pushed up to its stroke end, air taken inside the cylinder may cause damage to the piston packing. 3-80 WA430-6