Komatsu — Check Function of PPC Accumulator

Check Function of PPC Accumulator MAINTENANCE For details about handling the accumulator, see “Accumulator and Gas Spring” on page 1-50. Replace the accumulator every 4,000 hours or every two years. If the engine stops with the work equipment raised and it is impossible to start the engine again, it is possible, as an emergency measure, to actuate the valve with the oil pressure stored in the accumulator and lower the work equipment to the ground. 1. Set the parking brake switch to the ON position (A). 2. Raise the work equipment to the maximum height and then operate the lift arm control lever to the HOLD position (b). 3. Stop the engine. 4.

Leave the work equipment lock lever (1) in the FREE position. 5. Check and be sure the area around the machine is safe. Remark Carry out the procedure within two minutes after stopping the engine. If the machine is left with the engine stopped, the accumulator pressure will drop and it will be impossible to check the cause of the problem. 6. Set the lift arm control lever to the FLOAT position (d) and lower the work equipment to a point 1 m (3.3 ft) above the ground. 7. When the lift arm comes to the 1-meter position, return the lift arm control lever to the LOWER position (c) and lower the work equipment slowly to the ground.

If the work equipment stops while it is moving, the gas pressure in the accumulator has probably dropped. Contact your Komatsu distributor to have the accumulator inspected. WA430-6 3-87