Komatsu — Check Brake Disc Wear

MAINTENANCE 5. Depress the brake pedal and push in rod (2) fully. 6. Measure the amount of wear. Amount of wear (A) is the amount that end face (C) of the rod protrudes from end face (D) of the guide. Measure the amount of protrusion. Permitted wear limit (B) of the disc is the point where groove (E) of the rod is in line with end face (D) of the guide. When this point is reached, ask your Komatsu distributor to carry out inspection and replacement of parts. If the disc is near the wear limit, carry out inspection at shorter intervals, regardless of the specified inspection interval. 7. Install cap nut (1). Tightening torque: . . . . . . . . . . . . . . . .

29 – 39 N•m (22 – 29 lbf ft) Remark On new machines, the position of the guide is adjusted so that the end face of rod (2) comes to the end face of guide (3). For this reason, do not loosen locknut (4) except when replacing the disc. Carry out the operation with two workers; one worker depresses the brake pedal and the other worker pushes in rod (2). 3-86 WA430-6