Komatsu — Check Brake Disc Wear

Check Brake Disc Wear MAINTENANCE When checking the brake disc wear, turn the parking brake switch to the ON position (A) and set the frame lock bar to the LOCK position (L) to secure the front and rear frames. Make sure that the brake oil temperature is less than 60°C (140°F) before checking the brake wear. If the disc is near the wear limit, carry out inspection at shorter intervals, regardless of the specified inspection interval. When checking the brake disc for wear, there are four places (front axle and rear axle, left and right); use the same procedure to check all four places. 1. Set the parking brake switch to the ON position (A). 2.

Lower the work equipment to the ground; stop the engine; and wait for the temperature of all parts to go down. 3. Set the frame lock bar to the LOCK position (L) to lock the front and rear frames. 4. Remove cap nut (1). WA430-6 3-85