MAINTENANCE 4. Set a container to catch the oil under drain plug (P). 5. Remove front and rear oil filler plugs (1), then remove drain plug (P) to drain the oil. A: Front axle B: Rear axle Remove any mud and dirt from around the plugs before removing them. 6. After draining the oil, clean drain plug (P) and install it again. 7. Add oil to the specified level through plug hole (1). If your machine has the LSD (Limited-Slip Differential), be sure to use only the specified lubricating oil for this axle; refer to “RECOMMENDED FUEL, COOLANT, AND LUBRICANTS” on page 3-12. 8. After adding oil, check at oil level plug (1) that the oil is at the specified level.
For details, see “Check Axle Oil Level, Add Oil” on page 3- 38. 9. If the oil level is correct, install both oil level plugs (1) Replace Element in Air Conditioner Recirculation Filter, Fresh Air Filter Remove both the recirculation air filter and fresh air filter in the same manner as when performing the cleaning procedure. Replace both filters with new parts. For details about cleaning the recirculation air filter, see “Clean Element in Air Conditioner Recirculation Filter” on page 3-64. For details about cleaning the fresh air filter, see “Clean Element in Air Conditioner Fresh Air Filter” on page 3-60. 3-84 WA430-6