Change Axle Oil MAINTENANCE When changing the oil, turn the parking brake switch to the ON position and set the frame lock bar to the LOCK position to secure the front and rear frames. Immediately after stopping the engine, the parts and oil are very hot and may cause burns. Wait for the temperature to go down before starting the operation. When the plug is removed, oil may spurt out. Turn the plug slowly to release the internal pressure and then remove the plug carefully. Remark For operations where the brake is used frequently, change the axle oil at shorter intervals. Required Container to catch oil. Refill capacity:. . . . . . . . . . . . . . . . . . . . . . . Front Axle: 49 l (13 gal) .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Rear Axle: 40 l (11 gal) 1. Set the parking brake switch to the ON position (A). 2. Lower the work equipment to the ground; stop the engine; and wait for the temperature of all parts to go down. 3. Set the frame lock bar to the LOCK position (L) to lock the front and rear frames. WA430-6 3-83