Komatsu — Adjusting Seat

OPTIONS, ATTACHMENTS Adjusting Seat Stop the machine in a safe place before adjusting the operator's seat. Adjust the seat position at the beginning of each shift or when operators change. Put your back against the backrest of the operator's seat and adjust the seat so that it is possible to depress the brake fully. (A) Fore-and-aft adjustment Move lever (1) up; move the seat to the desired position; then release the lever. Fore-and-aft adjustment: . . . . . . . . . 210 mm (10 mm x 21 stages) . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.(8.27 in [0.39 in x 21 stages]) (B) Adjusting seat angle Move lever (2) up; move the seat cushion at the front up or down to set to the desired position; then release the lever. Adjustment range: Forward tilt: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3° Rear tilt: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11° Remark An air compressor built into the seat is used for adjustments (C) and (D). Turn the engine starting switch to the ON position before starting the adjustment. There is danger of damage to the air compressor. Do not keep lever (3) operated continuously for more than one minute.

(C) Adjusting seat height The seat height adjustment uses an air system and can be adjusted easily. When adjusting the height, pull lever (3) up fully or push it down fully (when pulling it up, pull it until you feel a click). When the seat is set at the desired height, release the lever. If the lever is kept pulled up, the position where the seat does not rise any further is the maximum height. When the seat reaches the maximum height, the suspension automatically goes down slightly to secure the amount of movement of the lever. If the operator raises his body from the seat or changes the amount of weight applied to the seat during adjustment, the air in the suspension may be discharged.

Adjustment range: . . . . . . . . . . . . . . . . . . . . . . . . . 80 mm (3.15 in) Remark If the lever is operated in the RAISE direction from the maximum height, the compressor may continue to operate for approximately eight seconds. This does not indicate any abnormality with the seat. If this happens, the compressor will stop automatically after approximately eight seconds. The compressor will also stop if the height control lever is operated in the LOWER direction. 5-14 WA430-6