Work Equipment Lever OPTIONS, ATTACHMENTS The work equipment lever (1) is used to control the lift arm and bucket. Lift Arm Operation Remark Do not use the FLOAT position when lowering the bucket. Use the FLOAT position when leveling, see “Leveling Operations” on page 2-123. Position (a): RAISE When the work equipment control lever is pulled further beyond the RAISE position, the lever is stopped in this position until the lift arm reaches the preset position of the kickout, and the lever is returned to the HOLD position. Position (b): HOLD The lift arm is kept in the same position. Position (c): LOWER Position (d): FLOAT The lift arm moves freely under external force.
Bucket Operation Position (e): TILT When the work equipment control lever is pulled further beyond the TILT position, the lever is stopped in this position until the bucket reaches the preset position of the positioner, and the lever is returned to the HOLD position. Position (b): HOLD The bucket is kept in the same position. Position (f): DUMP Kickdown Switch If the gearshift lever is in 2nd and kickdown switch (2) is pressed, the transmission will downshift to 1st. Use this when you need to increase the drawbar pull in digging operations.
If the transmission is in auto-shift and the travel speed is below 10.5 km/h (6.5 mph) in any speed range when traveling in either forward or reverse, the kickdown switch is actuated. It is possible to downshift to 1st. WA430-6 5-31