OPTIONS, ATTACHMENTS This makes it easy to carry out load and carry operations: Even if the travel speed is more than 10.5 km/h (6.5 mph), this switch can be used to downshift the transmission. Each time the kickdown switch is pressed, the speed range will downshift one range at a time (F4 F3 F2). When the torque converter is in the lockup condition (if equipped), the lockup is canceled. Remark When canceling the kickdown, operate the directional lever or the FNR switch. In manual shift, it can be canceled by operating the speed lever to any position other than 2nd. It is also possible to cancel the kickdown by turning the starting switch OFF.
In auto-shift, if the travel speed increases after the kickdown, the gear will be shifted up by the auto-shift. In auto-shift, when traveling at more than 18 km/h (11.2 mph) in 3rd or at more than 28 km/h (17.4 mph) in 4th, even if the kickdown switch is pressed, the transmission will not downshift. This prevents the engine from overrunning. Hold Switch The hold switch (3) is used to fix the speed range when traveling while using the automatic transmission. When the switch is pressed, the transmission is fixed in the speed range displayed on shift indicator (A) on the machine monitor and shift hold pilot lamp (B) will light up. When the switch is pressed again, the display goes out.
Use this function to select the desired speed range when traveling up or down hills or when carrying out operations such as grading. Remark When the torque converter is in the lockup condition (if equipped), the transmission cannot be fixed. When canceling the shift hold, operate the directional lever or the FNR switch. It can also be canceled by operating the speed lever and by switching the shift/manual selector switch to MANUAL. It is also possible to cancel the shift hold by turning the starting switch OFF. FNR Switch The FNR switch (4) is used to change the direction of travel of the machine. Position (F): FORWARD Position (N): Neutral Position (R):
REVERSE Before operating this switch, check that the following conditions are present: Directional lever is at N. Directional selector switch actuation switch is at ON. If the conditions are not present, the switch will not work. 5-32 WA430-6