Komatsu — LIFTING MACHINE

OPERATION TRANSPORTATION When lifting the machine, carry out the operation on flat ground as follows. 1. Start the engine, then swing the upper structure so that the work equipment is at sprocket (1) end with the track frame and upper structure set parallel. 2. Raise the blade fully. 3. Extend the bucket cylinder, arm cylinder, and boom cylin­ der fully. 4. When the boom swing has been operated to the left or right, operate the boom swing pedal to set the boom paral­ lel to the track frame, then set the pedal lock to the LOCK position. 5. Set the safety lock lever to the LOCK position (L). REMARK For machines equipped with a cab, there is only a safety lock lever on the left. 6.

Stop the engine, check that there is nothing around the operator's compartment, then get off the machine. For cab specification machines, close the cab door and front glass securely. 7. Install shackles to the lifting holes (2 places) on both ends of the blade, then install the wire ropes. 8. Pass the wire rope through the bracket on the boom (see diagram on right). NOTICE q Be sure to use the three brackets. Do not lift the machine with the boom or the upper structure swung. q Be careful not to get the hoses caught. 3-99