Komatsu — CHECK AND ADJUST RUBBER SHOE TENSION

MAINTENANCE PROCEDURE MAINTENANCE Prepare a grease gun. 1. Pump in grease through grease fitting (2) with a grease pump. 2. To check that the correct tension has been achieved, run the engine at low idling, move the machine slowly forwards (7 - 8 m), then stop the machine. 3. Check the rubber shoe tension again, and if the tension is not correct, adjust it again. 4. If the tension is still low after supplied grease, the rubber shoe needs to be replaced or the seal in the cylinder needs to be replaced. Ask your Komatsu distributor for replace­ ment. Loosening Track Tension It is extremely dangerous to release the grease by any method except the procedure given below.

If the track tension is not relieved by this procedure, please contact your Komatsu distributor. 1. Loosen plug (1) gradually to release the grease. 2. When loosening plug (1), turn it a maximum of one turn. 3. If the grease does not come out smoothly, move the machine forwards and backwards a short distance. 4. Tighten plug (1). 5. To check that the correct tension has been achieved, run the engine at low idling, move the machine slowly forwards (7 - 8 m), then stop the machine. 6. Check the rubber shoe tension again, and if the tension is not correct, adjust it again. 7. Check the track tension again, and if the tension is not cor­ rect, adjust it again. 4-34 WARNING