Komatsu — REPLACE RUBBER SHOES

MAINTENANCE MAINTENANCE PROCEDURE REPLACE RUBBER SHOES 4 (Machine equipped with rubber shoes) q Carry out this operation with two workers. The opera­ tor must move the machine in accordance with the sig­ nals from the other worker. q The rubber shoes are replaced with the machine raised, so it is extremely dangerous if the machine is lowered by mistake during the replacement operation. During the replacement operation, never move the rub­ ber shoe track except the rubber shoe track to be replaced. In addition, never go under or put any part of your body under the rubber shoe or track frame during the replacement operation.

q To check that the track tension is correct, run the engine at low idling, move the machine forward a dis­ tance equal to the length of track on ground, then stop the machine. NOTICE It is possible to change from the rubber shoe to the road liner and steel shoe. However, it is necessary to remove the idler guard and to carry out adjustment, so always contact your Komatsu distributor to have the replacement carried out. q Prepare a grease gun q Prepare a steel pipe Rubber Shoes Removal q It is extremely dangerous to release the grease by any method except the procedure given below.

If the rubber shoe tension is not relieved by this procedure, please contact your Komatsu distributor for repairs. q Check that all the grease has been released before rotating the sprocket to remove the rubber shoe. 1. Raise the chassis with the boom and arm. When doing this, operate the levers slowly. 4-35 WARNING WARNING