MAINTENANCE PROCEDURE MAINTENANCE REPLACE BUCKET TEETH 4 q It is dangerous if the work equipment moves by mis take when the teeth are being replaced. Set the work equipment in a stable condition, stop the engine, then set the safety lock levers securely to the LOCK position (L). q The pin is knocked out by force, so there is danger of the pin flying out. Check that nobody is in the sur rounding area. q There is danger of broken pieces flying during the replacement operation, so wear protective glasses, gloves, and other protective equipment. REMARK For machines equipped with a cab, there is only a safety lock lever on the left. Replace the bucket teeth before the adapter starts to wear. 1.
To make it possible to knock out the pin of tooth (1), set the bottom surface of the bucket on a block, check that the work equipment is in a stable condition, then set the safety lock lever to the LOCK position. Set so that thebottom face of the bucket is horizontal. 2. Use a hammer and drift to knock out lock pin (2). (If the drift is set against rubber pin lock (3) when it is hit, the rubber pin lock may break. Set it against the back of the pin.) 3. After removing lock pin (2) and rubber pin lock (3), check them. 4-38 WARNING