Komatsu — CHANGE OIL IN HYDRAULIC TANK, CLEAN STRAINER

MAINTENANCE MAINTENANCE PROCEDURE 4. Set the safety lock lever to LOCK position (L) and stop the engine. REMARK For machines equipped with a cab, there is only a safety lock lever on the left. 5. Open dust cover (1) fully until it is secured in position. (For details of the method of opening and closing the cover with the lock, see Section “In Case of Engine Rear Cover and Dirt Cover (3-28)“) 6. Loosen bolt (2), then remove plate (3) to the front. 7. Remove the cap from oil filler (F), and release the internal pressure. 8. Set the oil container under the drain plug under the machine. Using the handle, remove drain plug (P) and drain the oil.

Check the O-ring installed to plug (P), and if it is damaged, replace the O-ring. After draining the oil, tighten drain plug (P). Tightening torque: 68.6 ± 9.81N·m (7 ± 1kgf·m, 50.6 ± 7.2 lbft) q Take care not to get oil on yourself when you remove drain plug (P). 9. When opening (tilting) the floor, see Section “When opening (tilt open) (3-32)“ for details. 10. Loosen hose clamp (4), remove hose (5), then remove bolt (6) and take out strainer (7). 11. Remove any dirt stuck to strainer (7), then wash it in clean diesel oil or flushing oil. If strainer (7) is damaged, replace it with a new one. 12.

Secure strainer (7) with bolt (6), then install hose (5) and secure it in position with hose clamp (4). 13. After completing the adjustment, close the floor. For details, see Section “When closing (tilt close) (3-35)“. 14. Add the replacement amount of oil through oil filler (F). Check that the oil level is between the H and L lines on the sight gauge. 4-59