Komatsu — CHECK ALTERNATOR, STARTING MOTOR

MAINTENANCE PROCEDURE MAINTENANCE 15. Extend the boom, arm, and bucket cylinder fully as shown in the diagram on the right, remove the oil filler cap, then install the cap and pressurize the inside of the tank. NOTICE Be sure to pressurize the hydraulic tank. If it is not pres­ surized, the pump will suck in air, and this will adversely affect the equipment. 16. After replacing the oil, set each control lever to the neutral positionand run the engine idle at a low speed for 2 to 3 minutes, then start the normal work. CHECK ALTERNATOR, STARTING MOTOR 4 The brush may be worn or the bearing may have run out of grease. Contact your Komatsu distributor for inspec­ tion or repair.

If the engine is started frequently, carry out inspection every 1000 hours. 4-60