Komatsu — METHOD OF OPENING (TILTING) FLOOR

OPERATION DETAILED CONTROLS AND GAUGES When closing (tilt close) NOTICE Before closing the floor, check that there is no damage or abnormality in the wiring or piping inside the floor. If any damage or abnormality is found, please ask your Komatsu distributor to carry out repairs. 1. Remove lock pin (13) and insert it into storage hole (15). REMARK If lock pin (13) does not come out, do as follows. Machine equipped with canopy: Hold knob (9) and raise while removing lock pin. Machine equipped with cab: Hold knob (9) and lower while removing lock pin. 2.

Use your left hand to pull floor lock release lever (8) in the direction of the arrow (to the rear) while holding knob (9) with your right hand and pulling it down in the direction of the arrow (approx 45°). NOTICE q Lower slowly and check that there is no damage or catching of the wiring or piping. q When opening or closing the floor, do not let any part of your body enter the area under the floor. 3. Open engine rear cover (5) fully and secure it in position. (For details of the method of opening and closing the cover with the lock, see Section “In Case of Engine Rear Cover and Dirt Cover (3-28)“.) 4. Tighten 6 M14 floor tilt lock bolts (6). Tightening torque:

156.8 to 196 N·m (16 to 20 kgf·m, 115.7 to 144.7 lbft) REMARK If any bolt (6) is damaged, replace it with a genuine Komatsu part of the same size. 5. Close engine rear cover (5). 3-35