Komatsu — Walk-around Checks

OPERATION MACHINE OPERATIONS AND CONTROLS 5. Check of the undercarriage parts Check track shoe, sprocket, idler, guard for damage, wear, loose bolts, or leakage of oil from rollers, etc. Repair them if any trouble is found. 6. Check of the handrails and steps Check the handrails and steps for any damage or loosened bolts, and repair the damaged part and tighten the loosened bolts, if any. 7. Check for abnormality in gauges and monitor Check that there is no abnormality in the gauges and monitor in the operator's cab. If any abnormality is found, replace the parts. Clean off any dirt on the surface. 8.

Seat belt and mounting clamps Check that there is no abnormality in the seat belt or mounting clamps. If there is any damage, replace with new parts. 9. Check floor tilt lock bolts q Open the engine rear cover and check that 6 floor tilt lock bolts (1) are tightened properly. If any bolts are loose, tighten them. q If there is any up-and-down play in the floor plate, or if clearance (A) is too large (normal: approx. 5 mm (0.197 in)), lock bolts (1) may be broken or loose, so check lock bolts (1). If any abnormality is found, always carry out repairs your­ self or ask your Komatsu distributor to carry out repairs. 10. Check bucket with hook (if equipped) for damage.

Check that there is no damage to the hook, guide, or hook mount. If any abnormality is found, please contact your Komatsu distributor for repair. 3-41