Komatsu — STARTING ENGINE

. OPERATION OPERATION OPERATION OPERATION 6. When the engine starts, release the key in starting switch (2). The key will return automatically to the ON position (B). REMARK Immediately after an engine startup, keep the engine idling, and while the engine is idling, keep the foot off the deceleration pedal and do not operate the work equipment. 7. When the engine rotation stabilizes, return to the low idle (MIN) position of fuel control dial (1) and then carry out the warming-up operation. 3 - 88 2. Insert th e key into starting switch (2) and turn the key to the ON position 3. Chec k t hat e ngine pre-heating pilot lamp (3) on the monitor p.

key in the on position until the pre-heating pilot s off. monitor panel lights u p. 4. Maintain the key in lamp (3) goe s off. n position unti 5. When preheating pilot lamp (3) goes off, turn the key of ignition switch (2) to the START po sition (C ) to cra nk the engine. The ti me that preheating pilot lamp ( 3) stays on changes according to the ambient temper ature as shown in the table below. Ambient temperature Pre-heat time -3°C to -10°C (27°F to 14°F) 5 to 15 seconds -10°C to -20°C (14°F to -4°F) 15 to 32 seconds -20°C to -30°C (-4°F to -22°F) 32 to 45 seconds