Komatsu — STARTING ENGINE

. OPERATION OPERATION 10 to -30 ° C (50 to -22 ° F) Change 0 to 20 Engine Cooling Water Auto Warming-up Function This is a function to automatically warm up engine cooling water more quickly by raising an engine idling speed. When the turbocharger protection function and engine cooling water auto warming-up function are activated at the same time, the former takes priority over the latter. While the turbochargerprotection function is in operation, the engine revolution is held at 1200 rpm even if the fuel control dial is set at any rpm.

However, if the fuel control dial is held at the engine full speed (MAX) for more than three seconds, the engine will gradually pick up the speed up to the full idling. This function continues to work for a maximum of 10 minutes, or until the engine cooling water temperature reaches 30 ° C (86 ° F). If the deceleration pedal is depressed while this function is in operation, the engine rpm goes down below 1200 rpm. 3 - 89 REMARK Regardless of th e ambient temperature, if the key in starting switch (2) is turned from OFF position to left, preheating pilot l amp (3) will light up and preh eating will start.

(Pr eheating continues w hile the starting sw itch is held at the left.) f the preheating time, see the table in Step 5. g is being carried out, the preheating pilot lamp (3) lights up to show that preheating is being s not start with the above operation, wait for about 2 minutes, and repeat steps 3. And 4. For the details o f the preheating time, see the While preheatin carried out. If the engine doe s not start with the above op eration, wait for ab out 2 minutes, and re peat st eps 3. And The relationship between the actuation time o f the turbo protect f unction and th e engine cool ant temperature is as follows.

ontrol dial is operated within the time given below, the engine speed will not change. Even if the fuel c ontrol dial is operated within the time given belo w, the engine speed will not Turbo protect function The turbo protect fu nction is a function to protect the turbocharger b y keeping the engine speed at less tha n 1000 rpm immediately aft er the engine is started. When the turbochar ger protection function and e ngine cooling wate r auto warming-up fu nction a re activated at the same time, the form er takes priority over the latt er.

While the turboch argerprotection function is in operation, the engi ne revolution i s held a t 1000 r pm even if t he fuel control dial is set at above 1000 rpm. While the turboch argerprotection function is in operation, the engi ne revolution i s held a t 1000 r pm even if t he fuel control dial is op erated. When the turbo p rotect function is canceled, th e engine speed is s et to the speed for the position of the fuel control dial. The relationship turbo protect func tion and the temperature of th is as shown in th