. OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE WARNING WARMING UP OPERATIONS NOTICE 3 - 90 BREAKING IN THE NEW MACHINE NOTICE Your Komatsu machine has been thoroughly adjusted and tested before shipment from the factory. However, operating the machine under full load before breaking the machine in can adversely affect the performance and shorten the machine life. Be sure to break in the machine for the initial 100 hours (as indicated on the service meter).
NOTICE Your Komatsu m machine under fu ll load before breaking the machi ne in can adversely a ffect the performance and s horten the machine lif Be sure to break i n the machine for the initial 100 hours (as indicated o n the service meter). Make sure that y ou fully understand the conte nt of this manual, an d pay c areful attention to t he following points when breaking in the machine. Run the engi ne at idle for 15 seconds afte r starting it. During this time, do not operate the control levers o r fuel control dial. e for 5 minutes after starting it up. on with heavy loads or at high speeds.
Idle the engin e for 5 minutes after starting Avoid operati on with heavy loads or at hig Immediately after starting the engine, avoid sudden starts, sud den acceleration, unnece ssary sudden stops , and sudden chan ges in direction. If there has be en any abnormal actuation or tro uble, turn the starting switch key to the OFF posit ion. If the work equ ipment is operated without war ming the machine up sufficiently, the response of the work equipment t o the movement of t out the warmin he control lever will be slow and t he work equipment m ay not r espond as the opera tor desires, so always carry g-up operation.
Particularly in co ld areas, be sure to c arry out the warm-up operat ion completely. Do not accelerate been completed. Do not run the eng the engine suddenly until the warming-up operation h ine at low idle or high idle continuously for more than minutes. If it is necessary to continue to run the engine at idle, apply a load from tim to time or run the engine at a mid-range speed. ntrol dial (1) to the mid point b etween the low idlin ) and full speed (MAX) to star t up the engine. REMARK The machine ho lds an engine revolution at 1 200 rpm by means its engine coolin g water warming-up function until after the engin cooling water te mperature reaches 30°C (86 For more detai WEATHER (PA