. OPERATION OPERATION carrier rollers as shown in the shoe can create an abnormal method, see "CHECK and adjustment of track 3 - 115 TIPS FOR LONGER UNDER Undercarriage life greatly varies d epending on operation method, inspection and mainten operation, keep the following point OPERATION METHOD suits the type of soil to be encountered in service. stributor when selecting track shoes. cur during operation. oad on the blade until slipping stops. n or stops, unnecessary high speeds and sharp turns. traight line whenever possible.
When making turns, be careful not to allow the Select the track shoe that best Please consult your Komatsu di Do not allow shoe slipping to oc If shoe slipping occurs, reduce l Avoid sudden starts, acceleratio Always operate machine in a s traight line whenever possible. When making turns, be machine to stay to one side, so operation in both turning directions can be done properly. Make turns with the s and obstacles to prevent machine from riding over them while operating. e parallel to the inclination of the e slope. Also when stopping the ine should face the top of the left or right during digging dig with the incline. Move the nd start to dig again.
arry out work that exceeds its cludes cases where the idler or d when the machine meets of the machine during dozing or largest possible radius. Prior to operation, clear boulder s and obstacles to prevent machine from riding over the On a slope, operate the machin slope. Do not operate across th machine on a slope, the mach slope. When ground inclines to the operations, do not continue to machine back to level ground a Do not force the machine to c working capability. Such work in sprocket come off the groun obstacles that resist the power ripping operations.
INSPECTION AND ADJUSTME Adjust the track shoe tension to The track shoe tension can be "a" between the front idler and figure at right. While this clearan (0.8 to 1.2 in), increase the tensi decrease on the clayish ground An excessively loose track s vibration to the machine during teeth to wear prematurely. (For an inspection and maint TRACK SHOE TENSION, ADJ that section, carry out an insp shoe tension.) Check idler rollers for oil leakag nuts. If any trouble is detected,