. MAINTENANCE SERVICE PROCEDURE 2. Remove three clips (2), then remove cover (3). and evacuator valve (6). indicator (1) and return the yellow 4 - 22 REPLACING ELEMENT e cover. 1. Ope n the left engine sid 3. Rem ove outer element ot remove inner ele ment (5) at this time , however. 4. Clea bod NOTICE f the oute r element and cover are installed when the i nner elemen t is not nstalled p roperly, the outer ele ment may break. When inst allation is correct, pro trusion "a" of the i nner element from the air cleaner b ody is 35 mm. 5. Rem ove inner element (5), then quickly install the new inner ent. the inner element in properly and check that it is fitted rely.
he new outer element (4) in position. ace O-ring (7) for cover (3) with new one. he arrow mark on cover (3) at the top, install to the air er body, then secure with clip (2). elem Push secu 6. Set t he new outer elem ent (4) in positio 7. Repl ace O-ring (7) for c over (3) with ne w on 8. Set t he arrow mark on cover (3) at the clean er body, then secu re with clip (2). the air 9. Push n to its original pos REMARK mmedia yellow piston of the dust indicator m ay go to the 2nd position, bu t thi s does not indic ate any abnormalit 10. Clos e the left engine sid