Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 5. Direct dry compressed air (Max. 0.69 MPa (7 kg/cm 2 , 99.4 the element. NOTICE When cleaning the element, do not hit or beat it against anything. Do not use an element whose folds, gasket or seal are damaged. the inner element is not fitted securely, push it in properly. CAUTION scratches or damage. 8. Set the cleaned outer element in position, then secure cover (3) with mounting clips (2). 9. Push the button of dust indicator (1) and return the yellow piston to its original position. 10. Close the left engine side cover. 4 - 21 NOTICE The inner element must not be used again even after cleaning.

When replacing the outer element, repla ce the inner element at the same time. PSI)) from the inside of the direct the compressed air again from the inside. 1) Replace any outer e times or used for 1 ye same time. 2) Even if the outer elem 5 kPa position immedi and the outer element outer element along its folds. Then from the outside along the folds, and ent has not been cleaned 6 times, if the yellow piston in the d ust indicator goes t o the ately after cleaning (when the engine is running at high idlin g, replace both the i nner . 6. If small holes or thinner p ight through it after cleaning, replace element, check that the inner element is f itted securely.

If When installing the cover (3), chec k O-ring (7) and replace it if there are an