Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WARNING 4 - 24 To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant d 68%. Supercoolant between 30% an When deciding th e ratio of antifreeze to water, check t he lowest temperature in the past, a nd decide fr om the mixing table given below . er to estimate and temperature about 10°C (18°F) lower when deciding the mixing ratio. depends on the ambient temperature, but it should always be a minimum of 30% by volume mount of coolant x 100).

It i s actually bett er to estimate and t emperature abou t 10°C (18 °F) lo we r whe n deciding the mixing r The mixing ratio depends on the a alway (antifreeze/total a mount of coolant x Even in areas wh ere it is not necess ary to prevent fre ezing, use Supercoolant (AF-NAC) at a mixing r atio of at least 30% to prevent c orrosion of the coo ling system. The freezing tem perature of undilute d antifreeze is -1 5°C (5°F). Do n ot store undiluted a ntifreeze at a temperature of below -15°C ( 5°F). ter and antifreeze Mixing rate of wa Min. atmosph temperature eric °C - °F 1 10 -15 -20 -25 -30 4 5 -4 -13 -22 Amount of antifr liter 1 eeze US gal 2.

1.1 13.3 15.2 17.0 18.5 93 3.51 4.02 4.49 4.89 Amount of wa liter 2 ter US gal 6. 5.9 23.7 21.8 20.0 18.5 84 6.26 5.76 5.28 4.89 Volume ratio (%) 3 0 36 41 46 50 Antifreeze is fla mmable, so keep it aw ay from flame. Antifreeze is tox ic. When open the dra in valve, be carefu l not to get water containing antifreeze o n you. If it ge ts in your eyes, flush your eyes with large amount of fresh water and see a doctor a t once . When changing the coolant or drainin g the coolant from the radiator before c arrying out repairs, ask a specia list company to handle any coo lant containing antifr eeze, or contact y our Komatsu distributor. Antifreeze is toxic, so never pour it into e. tributor.

A into drainage water ditches or drain it onto the ground surfac Use antifreeze an d appropriate wate r for diluting (for d etails, see "COOLANT A ND WATE R FOR DILU TION (PAGE 4-6)") use of an antifreeze density gauge to control the mixing proportions. ner whose capacity is larger than the specified coolant volume to catch drained coolant. o supply antifreeze coolant and water. ine and tighten 2 valves of the corrosion resistor. We recommend use of an antifreeze density gauge t o control t he mi xin Prepare a contai ner whose capacity is larger than th e specified coolant volum e to catch drained coo Prepare a hose t o supply antifreeze coolant and wat 1 .

Stop the eng ine and tighten 2 va lves of the corro