Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE until it hits the stopper and by so hits the next stopper, while the radiator is filled with water, idling speed. After the water temperature rises above 90 ° C (194 ° F), run the engine for about 10 minutes. 4 - 25 2. Turn radiator cap (1) slowly u 3. doing, relieving the internal pr Turn radiator cap (1) until i depressing it. Keep turning th last stopper. 4. Put containers to catch the coo bottom of the radiator and und the cylinder block. 5. Open drain valve (2) and drain After draining the antifreeze so then fill with clean water. After start and run the engine at lo 6.

Stop the engine and open dra in valve (2), (3) to drain the water. the cooling system with cleaning agent. the instructions for the cleaning agent. , then open 2 valves. or replacing the corrosion resistor, see "REPLACE CORROSION RESISTOR eze until it overflows from the water filler. 7. After draining the water, clean For the cleaning method, see 8. Replace the corrosion resistor For details of the procedure f CARTRIDGE (PAGE 4-74)". Close drain valve (2), (3). 9. 10. Add coolant mixed with antifre Decide the proportions of antifr eeze and water according to the table for the mixing rate of water and antifreeze. 11. To remove air in the cooling s (While doing this, leave the ra 12.

Drain the coolant from sub-ta sub-tank, then add water until FULL and LOW marks. 13. Stop the engine, wait for appr until the coolant level is near t the cap. Check the coolant lev