Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE following manner. ADJUSTMENT WARNING 4 - 26 CHECK TRACK SHOE TENSION, AD The wear of pins and bus hings on the und ercarriage will vary with the working conditions a nd types of soil. It is thus necessar y to continually inspect the track tension so as to maintain the standard tension. Carry out the check and adjustment und er the same c onditions as becomes clogged with m ud, measure wit h the track clog ged with INSPECT ION machine on level ground (stop with the transmission in Stop the FORWA RD without appl ying the brake).

T hen place a st raight bar o n the tra ck shoes betwe en the carrier roll er and the idler as shown in the figu grouser a re, and measu t the midpoint. I re the clearance f the clearance (a between the ba ) is 20 to 30 m r and the m (0.79 to 1.18 in), t If the tra he tension is st ck tension is n andard. ot at the standard value, adjust it in the There is da nger of plug (1) fl ying out under the h igh internal pres sure of the grease. N ever loosen plug (1) more than 1 tur Never loo sen any part oth mounting direction of plug If the trac k tension cannot please con tact your Komats u distributor. WHEN INCREASING TENSI ON Prepare a grease pump. 1. Pump 2. To ch mach 3. Chec adjus 1.

Pump in grease thro ugh grease fitting (2) with a grea se pump. 2. To ch eck that the cor rect tension has b een achieved, move the ine backwards and forwards. 3. Chec k the track tens ion again, and if t he tension is n ot correct, t it again.