Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEANING WITH COMPRESSED AIR WARNING It opens water or 4 - 32 4. Turn engine sta rting switch key (1) t o the ON position t o start up the engine. T hen the co oling fan beg ins to rotate in the reverse d irection. at high idle. for running the engine at high idle as follows according to the condition of clogging. g: 1 to 2 minutes ging: 2 to 3 minutes g the cleaning, run the engine at low idle for approx. 10 seconds. witch (1) to the "OFF" position and stop the engine. witch (1) to the "ON" position. 5. Run the engine Select the time for running the engi ne at high idle as follows according to th e conditio n of clogging Normal cloggin g:

1 to 2 minutes Excessive clog ging: 2 to 3 minutes 6. After completin g the cleaning, run t he engine at low i dle for approx. 10 seco 7. Turn starting s witch (1) to the "OFF " position and sto 8. Turn starting s witch (1) to the "ON" position. 9. Check first that cooling fan operatio n checking lamp ( 4) is unlighted and the n start up the engine. The cooling fan begins to tu rn in the normal dire ction. Directing compres sed air, pressurized wa ter, or steam directly at your body, or using th ese and ca using dust to f ly may cause personal injury. A lways wear protective glasses, anti-dust m ask, and other protective equipment .

When carrying out cleaning, always stop the engine and ch eck that the fan is not ro tating. If y ou touch the f an when it is rotating, it will cau se serious personal in jury. CLEANING OF RADIATOR FINS AND AFTER-COOLER FINS When the radiator f ins and after-cooler f ins are clogged or lots of dust is accumul ated, clea n them with c ompressed air 1. Remove bolts ( 2. Open the A sid approx. 10 mm 3. Open the B sid e of the radiator ma 4. Blow off dirt, du st and dry leaf shred s clogging the rad and after-coole r fins with compres sed air. Steam a may also be us ed for cleaning inste ad of compressed REMARK Check the hydrau lic cooler hoses.

If any hose is cra hardened by age, r eplace with a new ho se. Also check an all loose hose clam ps. 5. When closing th e radiator mask, alw ays push in the A then push in th e B side, align the b olt holes, and tigh (1).